Programming
(cont)
12
Please Remember
– Only use Tablet or Pellet Salt in Your Softener!
To advance or reduce the displayed number to your required setting, use the
or
buttons.
Once the required setting is displayed it may be set by pushing the
SELECT
button once more.
SET THE REGENERATION TIME
The display will flash 02.00 recharge time, which is the pre-set factory
setting. If you wish to change this time then proceed as follows: (if not,
press
SELECT
and proceed to the next section).
NOTE:
2.00 am is chosen because any household water used during
recharge will be replaced with hard water. Consequently a time is required
when very little, if any, water will be used. To select a different regeneration
time use the
or
buttons, to adjust one hour at a time. Once the
required setting is displayed it may be set by pressing the
SELECT
button
once more. Recharge will last for approximately 1 hour.
HARDNESS
19
RECHARGE TIME
AM
2:00
