Connecting the System to ISDN
using NT1 Network Adapter
Placing the NT1 Adapter
For convenience the NT1 adapters could be placed inside the video
systems cabinet.
Connecting Cables
•
Connect the first ISDN cable from ISDN1 on the video system
(codec) to the S-interface on your first NT1 network adapter.
•
Connect the other ISDN cables to the appropriate NT1 network
adapters.
•
Connect the U-interface of your NT1 adapter to the line provided
from your network provider.
ISDN Cables
•
Connect the shorter ISDN cable (RJ45 connectors) delivered with
the NT1 between the video system (codec) and the NT1 adapter.
•
Connect the longer ISDN cable between the NT1 and the connector
(RJ45) at the wall socket.
Configure the Video System
To configure the video system go to Control Panel > Network > ISDN/
External/Leased E1/T1 and:
•
Set Network Type to
ISDN-BRI
•
Go to ISDN-BRI Settings and select
ISDN SWITCH TYPE
•
Go to
LINE 1 SETUP
:
•
Enable Line 1
•
Enter ISDN Line Numbers (+ SPIDs if required).
•
Configure the other lines to be used.
Some software versions do not support 6 ISDN lines, therefore
some of the Line # Setup entries may be grayed out.
•
Disable unused lines.
•
Check if you need to configure the
ADVANCED ISDN SETTINGS
.
Setting up a call
•
Go to the
CALL MENU
and select
MAKE A CALL
•
In the Call Menu, open
DEFAULT CALL SETTINGS
•
Set
NET
to
ISDN
•
To use these settings for this call only, select the
OK
button.
To save the settings as your new Default Call Settings select
SET AS
DEFAULT
before pressing the
OK
button.
•
Go on with your call and enter the number to be dialed.
D14033.06—AUGUST 2010
247
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
Using the system
