MENU ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODUCT
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
LINE SETTINGS
E1 CRC-4
E1 CRC-4 is used for most E1-PRI configurations.
ON:
Select On if E1 CRC-4 is supported by your E1 network equipment.
OFF:
Select Off if E1 CRC-4 is not supported by your E1 network equipment.
CRC - Cyclic Redundancy Check
All MXP
systems
which has
ISDN-PRI
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
ADVANCED ISDN SETTINGS
SUB ADDRESS
Using a Sub Address enables you to connect up to eight ISDN terminals to the same ISDN telephone number
and line. The terminals are addressed by using different sub addresses.
To call a terminal with a sub address, separate the ISDN telephone number and the sub address with a ‘*’.
Example:
12345678*2
(up to four digit sub addresses are possible)
This service is dependent on your service provider and has
limited access on some ISDN networks.
All MXP
systems
which has
ISDN-PRI
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
ADVANCED ISDN SETTINGS
VALIDATE NUMBERS (MSN)
The use of MSN (Multiple Subscriber Number) enables you to attach different ISDN terminals, with different
numbers, to the same physical ISDN telephone line. If available this service can be ordered from your
telephone company.
ON:
When set to On only calls to the numbers specified in the Line Setup menus will be answered.
OFF:
When set to Off all calls will be answered.
MSN - Multiple Subscriber Number
All MXP
systems
which has
ISDN-PRI
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
ADVANCED ISDN SETTINGS
PARALLEL DIAL
Parallel Dial is used when setting up bonded calls.
ON:
Channels will be dialed and connected in parallel when setting up a BONDING call.
OFF:
Channels will be dialed one by one, which may increase the dialing time.
Bonded ISDN calls - The bridging of two or more ISDN
channels to achieve higher data rates.
All MXP
systems
which has
ISDN-PRI
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
ADVANCED ISDN SETTINGS
SEND OWN NUMBERS
ON:
The system will send its own numbers to the far end.
OFF:
The system will not send its own numbers to the far end, but please note that the network may still
send your numbers to the far end.
All MXP
systems
which has
ISDN-PRI
Control Panel >
Network >
ISDN, External, Leased E1/T1 >
ISDN-PRI Settings >
ADVANCED ISDN SETTINGS
SENDING COMPLETE
Some PBX’s and Telco switches need to see the Sending Complete message.
ON:
The system will send the ISDN message information element Sending Complete.
OFF:
The system will not send Sending Complete. Default is “Off”
All MXP
systems
which has
ISDN-PRI
D14033.06—AUGUST 2010
205
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
The settings library
