MENU ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODUCT
Control Panel >
Network >
LAN Settings >
H.323 Settings >
GATEKEEPER SETTINGS
H.323 ID
When using a Gatekeeper, the system will send a message to the Gatekeeper containing both the E.164 Alias
and the H.323 ID of the system.
The H.323 ID of the system may be specified here. The System Name is used if no H.323 ID is entered.
Example: “
Alice Wonderland
”, “
System 01
”
H.323 is an umbrella recommendation from the ITU-T, that
defines the protocols to provide audio-visual communication
sessions on any packet network.
Control Panel >
Network >
LAN Settings >
H.323 Settings >
GATEKEEPER SETTINGS
DISCOVERY
AUTO:
The system will automatically try to register to any available Gatekeeper. If a Gatekeeper responds
to the request sent from the codec within 30 seconds this specific Gatekeeper will be used. This
requires auto discovery on the Gatekeeper as well. If no Gatekeeper responds, the system will not use a
Gatekeeper for making H.323 calls and hence an IP-address must be specified manually.
MANUAL:
The system will use a specific Gatekeeper identified by the Gatekeeper’s IP-address.
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
GATEKEEPER SETTINGS
IP ADDRESS
Defines the Gatekeeper IP-address.
If your system is part of a TANDBERG Expressway™ firewall traversal solution and is placed outside the
firewall, you should register the IP address of your Border Controller as the Gatekeeper IP address and set
H.323 Call Setup to Gatekeeper.
Requires the following configurations on the video system:
•
H.323 Call Setup: Gatekeeper
•
Gatekeeper Discovery: Manual
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
GATEKEEPER SETTINGS
AUTHENTICATION MODE
AUTO:
If Authentication Mode is set to Auto and the Gatekeeper indicates that it requires authentication, the
endpoint will automatically try to authenticate itself to the Gatekeeper.
OFF:
If Authentication Mode is set to Off the system will not try to authenticate itself to a Gatekeeper, but will
still try a normal registration.
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
GATEKEEPER SETTINGS
AUTHENTICATION ID & AUTHENTICATION PASSWORD
The system sends the Authentication ID and the Authentication Password to a Gatekeeper for authentication.
Requires that the Authentication Mode is set to Auto. The authentication is a one way authentication from the
endpoint system to a Gatekeeper, i.e. the endpoint is authenticated to the Gatekeeper.
If the Gatekeeper indicates that no authentication is required, the endpoint will still try to register.
All MXP
systems
D14033.06—AUGUST 2010
212
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
The settings library
