Tandberg Data
Installing Your Tandberg DLT VS160 Drive
Tandberg DLT VS160 Installation and Operations Manual
2-13
Note:
If the SCSI cable that came with your SCSI host adapter
already has a terminator built into it, do not use another
terminator. An example of such a cable is shown in Figure 2-7.
Figure 2-7: SCSI Ribbon Cable with Terminator Built-in
2.4.4
Installing your DLT VS160 Internal Drive
This is the final installation stage, which requires that you
install your DLT VS160 Internal Drive in the host server or
workstation and attach the SCSI and power cables.
To install your DLT VS160 Internal Drive, follow these steps:
1.
Shut down the operating system and turn off the selected
server or workstation. Turn off all attached accessory
devices, such as printers and other SCSI devices. Remove
the power cables from the host server or workstation and all
attached accessories. Failure to follow these instructions
may result in damage to your DLT VS160 Internal Drive or
other devices.
Terminator
SCSI Ribbon Cable
Supplied with SCSI
Host Adapter
