Tanco A Series, Руководство оператора, Страница: 26 / 72

Tanco Autowrap - A200 EH
Operator’s Manual
25
Operator Setup Menu
The default settings for the machine are developed by Tanco for optimal operation of the machine. However, the operator can change certain parameters in the ‘Operator Setup’ menu to
take account of operational conditions.
Menu No. Parameter Default Units Description
Target No. of Wraps 16
Operator Level
4.01 Contrast 2
4.02 Film Break OFF Switches on or off film break sensor
4.03 Auto Off-Load OFF Switches on/off the automatic offloading after wrapping. If this is set to yes, then if the
controller is switched off and back on, the Enter button (arrow) must be pressed to confirm
that Auto Off-Load is still required.
4.41 Remote Type RF Sets controller for remote control type. (RF=Radio control)
4.17 Tip Up 4.0 Seconds Time from cutter closing during tipping to fully tipped
4.18 Tip Up to Down 0.3 Seconds Time between tipping up and tipping starting back down
4.19 Tip Down 4.8 Seconds Table tipping down time
4.2 Fast Last Rev. 1.2 Seconds Time table continues in fast speed on last wrap revolution
4.35 Language English Sets controller language
Technician Level (Pin 1,2,3,4)
5.01 Sequence A200 Sets controller program for machine model.
5.02 Slow Start Time 2.0 Seconds Time table runs in slow speed at start of wrapping
5.03 C&S Open Time 2.5 Seconds Cutter opening time to release film during wrapping.
5.04 C&S Close time 1.5 Seconds Cutter closing time during tipping
5.06 Tip to Rotate 0.3 Seconds Not used on this model
5.09 Wrap T to Stop 0.2 Seconds Time delay for table to stop after passing magnet at at end of wrapping before reversing to
tip position
5.11 Tip Pause 1.5 Seconds Time tipping pauses for cutter to close
5.12 C&S Open 4.0 Pulses Number of table turns before film is released
5.63 Reverse Time 2 0.0 Seconds Time table reverses at end of wrapping to tip latch position
5.64 Tip Posn Check Yes Seconds Controller checks that table is in correct position for tip.
5.25 RPM Alarm *35 Seconds Maximum table wrapping speed.
5.28 Set Default Sets controller back to its default settings.
7. EH CONTROLLER INFORMATION
*Note: You can also select RF LEARN. This is used to pair the controller to the frequency of the remote control unit. This needs to be done if you change the remote control transmitter
unit. Press enter on the controller and press and hold the stop button on the transmitter. There will be a beep and a code will appear on the display. The remote is now learnt and ready
to use.