Tanco A Series, Руководство оператора, Страница: 23 / 72

Tanco Autowrap - A200 EH
Operator’s Manual
22
Manually interrupting an automatic wrapping cycle
Press the STOP switch. Pressing the R3 switch after switching the controller back on will resume the auto-wrap cycle from where it stopped.
For safety reasons, if it is necessary to work on the machine (e.g. in the event of a film break or the film running out), then it is strongly recommended that you disengage the machine
power source.
Manual options in Automatic mode
With the controller in automatic mode, the following manual functions are possible.
-
Slow Wrap (L3): (only enabled outside of the wrapping sequence). Press R3 to resume the normal fast wrap.
-
Reverse Table (L4): (only enabled outside of the wrapping sequence). Press this button to nudge the table backwards to the desired position.
-
Add 1 Wrap (R4): Each time you press this button an additional wrap will be put on the current bale if the wrapping sequence is in progress, or onto the next bale if the automatic
cycle has not yet been started. You can add as many wraps as required.
-
Load Up/Load Down (R5/L5) If the ‘Autoload’ sequence is not selected, then you can engage and pick up the next bale while the current bale is being wrapped.
Operation in Manual mode
‘M’ on the display indicates that the controller is set in manual mode. If not, press L6 to select. In manual mode you have total control of every stage of the wrapping cycle. The software
logic determines which manual functions can be activated at any point in the wrapping cycle. Should the operator incorrectly select a function at a certain stage during the wrapping
cycle, then that operation will not be performed.
7. EH CONTROLLER INFORMATION