Tanco A Series, Руководство оператора, Страница: 22 / 72

Tanco Autowrap - A200 EH
Operator’s Manual
21
7. EH CONTROLLER INFORMATION
Operation in Automatic mode
The controller is generally used in automatic mode.
AUTOLOAD
On the A200 model if a time is set for Load Up (5.0 approximately) in Operators Setup, then bale loading is incorporated into the automatic cycle for complete ‘one touch wrapping’. If
Load Up is set to time 0.0, the bale loading must be performed manually
Note: ensure that the turntable is in correct the loading position (with the film cutter on the opposite side to the load arm) before commencing autoload. The machine can be damaged if
this is not observed.
‘A’ on the display indicates that the controller is set in Automatic mode. If not, press L6 to select.
AUTOLOAD Sequence
Bring the machine up to the bale and press the R6 switch to commence the automatic sequence – Load, Wrap.
-
1. Bring the machine up to the bale, then press and hold the R5 switch to load the bale.
-
2. Press and hold the L5 switch to lower the lift arm.
-
3. Press the R6 switch to commence the automatic wrapping cycle. The cycle is completed when the target number of wraps has been reached.
Note: the lift arm must be in the safe lowered position for automatic wrapping to start.
-
4. Press the R1 switch to tip the bale off and automatically position the table for loading.
Note: Ensure that the turntable is in the correct offloading position (with the film cutter to the front) before commencing offloading. The machine can be damaged if this is not obser
ved.
AUTO OFFLOAD
If Auto Off-Load (in Operator Setup) is set to ON the bale will be tipped off automatically without pressing the off-loading button.
Note: For SAFETY, if Auto-Offload is set to ON and the controller is powered off and on again, the operator will be asked to confirm that Auto Off-Load is still required. This is done by
pressing the Enter arrow button. Note: Auto Off-Load should only be used where it is safe to do so.