Tanco 1400 Autowrap, Руководство оператора, Страница: 15 / 132

Tanco Autowrap - 1400
Operator’s Manual
14
6. Machine Setup
Mounting of the Machine
Be careful! There is a danger of being crushed when working implements are fitted and connected.
Carry out the fitting procedures slowly and carefully, and use separate and approved lifting equipment
to make the work easier. Note the section on safety precautions and pay attention to the various safety
decals displayed on different parts of the bale wrapper.
Attaching to the Tractor
The 1400 can be either connected to the tractor lower links using Linkage Attachment or by removing
this it can be attached to the tractor hitch using the Hitch Eye.
If the lower link bracket is used the Hitch Eye should be attached in the lowest position; this will allow
greater movement.
If attached to the tractor hitch it is recommended that the machine is attached to the Clevis Hitch rather
than the Pick-Up Hitch. This gives more clearance between the Drawbar and the tractor’s back wheels.
The Drawbar does not run directly behind the tractor. In transport the Drawbar runs nearer the left wheel
so the minimum turning circle to the left is reduced. In the working position this is the case for turning
to the right. When the machine is attached to the tractor the Drawbar Leg must be folded up to the
Drawbar by removing the Drawbar Pin; swing the Drawbar Leg upwards and fit the Drawbar Leg Pin to
Position B. (See Fig. 3 Overleaf).