VOIP-600
Series Phone
Configuration / Operation Manual
Page
35
of
94
Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
iii.
Remote Side Key Codes
Configure the Key Code sequence to be used by the remote side to activate the corresponding
Auxiliary Output.
Use the drop-down menu to select the duration for which the Auxiliary Output should remain
active (i.e.
ENTIRE CALL
(deactivates after the termination of the call),
CONTINUOUS
(activated indefinitely until deactivated by a deactivation event), or
CUSTOM
(activated for the
specified duration in seconds).
iv.
Local Key Codes
Configure the Key Code sequence to be used by the Local User to activate the corresponding
Aux Output device
9
.
Use the drop-down menu to select the duration for which the Auxiliary Output should remain
active (i.e.
ENTIRE CALL
(deactivates after the termination of the call),
CONTINUOUS
(activated indefinitely until deactivated by a deactivation event), or
CUSTOM
(activated for the
specified duration in seconds).Configure the Key Code sequence to be used by the remote side
to activate the corresponding Auxiliary Output.
3.
Configure various events on which the Auxiliary Output(s) needs to be deactivated.
i.
Button Events
The button events are available only when the Buttons are programmed for Autodial mode (Refer to
4.6.1 Buttons: for
Autodial
).
Configure the Auxiliary Output deactivation on Button #1 and/or Button #2 when a call is
INITIATED
,
ANSWERED
, or
TERMINATED
.
ii.
Auxiliary Input Events
Configure the Auxiliary Output deactivation on activation/deactivation of Auxiliary Input #1,
Auxiliary Input #2, and Auxiliary Input #3.
iii.
Remote Side Key Codes
Configure the Key Code sequence to be used by the remote side to for deactivation of the
corresponding Auxiliary Output
10
.
iv.
Local Key Codes
Configure the Key Code sequence to be used by the Local User for deactivation of the
corresponding Auxiliary Output.
v.
On Selected Events
Configure the Auxiliary Output deactivation on selected events as specified above.
vi.
On Call Transfer
Configure the Auxiliary Output deactivation on call transfer.
4.
Click
Apply
to save settings.
Note
You cannot use the same event for activation and deactivation of the same Auxiliary Output.
9
If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
10
If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
