VOIP-600
Series Phone
Configuration / Operation Manual
Page
17
of
94
Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.4.2. SIP Settings
This page is used to configure the phone number, SIP registrars and outbound proxy details.
Login → Network → SIP Settings
Figure 6 SIP Settings
To configure SIP settings:
1.
Enter the
Phone Number
(number used to call from other SIP endpoints).
2.
Enter the
Fully Qualified Domain Name
or the
IP Address
of the SIP Gateway/Proxy. Secondary
and Tertiary FQDN or IP Addresses can be assigned for failover. There is a 30 character limit for this
field. If Secondary and Tertiary Registrars are not used, then voip500.local is the default placeholder.
3.
Check or Uncheck
Register
to enable or disable the SIP registration.
4.
Enter
SIP registrar
details: (Secondary and Tertiary details can be assigned for failover)
Username
: This is an optional field however it is required when Authentication is enabled on the
SIP registrar. Valid entries include alphanumeric and special characters (‘*’, ’.’, ’-‘, No spaces
allowed)
Password:
This is an optional field however it is required when Authentication is enabled on the
SIP registrar. Valid entries include alphanumeric and special characters (‘*’, ’.’, ’-‘, No spaces
allowed)
IP Address and Port
: Configure the IP Address and Port of the SIP registrar on which you want
to register the phone. Default port is 5060. Valid port range is 1024-49151.
Re-registration Time
: Configure the registration refresh time. On expiration of this time interval,
the phone automatically sends a new register request to the registrar. Default re-registration time
is 3600 seconds. Valid range is 10-14400 seconds.
1
3
4
6
4
2
5
