TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel.: +48 59 821 13 40
e-mail:
13
5.
Use of the machine
The manufacturer ensures that the machine is fully operational and has been checked in
accordance with quality control procedures and is approved for use. However, this does not
release the user from the obligation to check the machine upon delivery
.
Before each use of the swath conditioner, check its technical condition,
especially the condition of the tine assembly, drive system and guards.
5.1. Linking the machine – swath conditioner assembly
Make sure that the mounting elements of the vehicle and the machine are
properly matched to each other, so that they guarantee safe assembly and
operation. In case of any doubts, please contact the vehicle or machine
manufacturer.
I.
Installation of the vehicle and machine suspension system.
The machine is mounted on the three-point linkage of the tractor or vehicle. To facilitate
mounting, the lower arms should be at the height of approx. 350mm. After linking the
machine, adjust the length of the upper link so that the position of the lower part of the
body is parallel to the ground. The chain of the tractor lower rods should be adjusted so that
the lateral play of the machine is minimal. Depending on the type of the three-point hitch,
original safeguards should be provided. Each time during assembly, check the condition of
the connecting elements: pins and pivots. In the event of wear, they must be replaced with
new ones.
II.
Machine drive shaft assembly.
After mounting the machine on the three-point linkage, attach the PTO, and then raise the
support to the upper position.
To power the swath conditioner, use only the original PTO shaft, marked with
the CE mark, along with original covers.
Dismantling the machine takes place in the reverse order, with special safety when
dismantling the mechanical system that separates the machine from the vehicle.
