TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel.: +48 59 821 13 40
e-mail:
18
Check the oil level in the gearbox every 50 operating hours. At the same time, it is
recommended to change the oil in the gearbox at least once a year.
The recommended oil is
SAE 90 API GL-4 in the amount of 0.9l.
It is important to check the clearance of the axles and shafts. In the event of noticeable play,
replace the bearings (always in pairs) with new ones according to the spare parts catalogue.
Lubricate PTO shaft after removing it from the machine. The telescopic part of the shaft
should be lubricated at least after 8 hours of operation - with the shaft fully extended and
after removing the dirt.
6.5.
Post-season maintenance
It covers all activities listed under after-work maintenance. Additionally, the machine should
be stored under a roof on a flat and hard surface. Pay attention to the tightness of the paint
coat. In the event of defects, clean these places and fill in the gaps by applying a fresh layer
of protective paint.
6.6.
Scraping, environment
If the machine is completely worn out and does not allow for further use, it should be
withdrawn from use. This also applies to current repairs and replacement of damaged parts.
For this purpose, the machine must be thoroughly cleaned and drained of operating fluids
and transported for disposal. Then disassemble the machine, sort the parts according to the
type of materials used. Separated parts should be delivered to a scrap yard or utilization
point.
The machine is a product that is fully environmentally friendly. The materials used for
production are 97% recyclable. Worn machine parts must be disposed of in accordance with
with local environmental regulations. Throughout the entire service life, care must be taken
to prevent oil leakage, which may contaminate the environment.
