Takeuchi 190100003, Руководство оператора

Страница: 205 / 305

5-39
MAINTENANCE
AFTER THE INITIAL 100 HOURS (ONLY FOR NEW MACHINES)
<Rear>
2. Place a pan under the plug (2) to catch the
waste oil.
3. Remove the plug (1), (2) and (3) and drain
the oil.
4. Tighten the plug (2).
· Tightening torque: 35 to 50 N · m (25.8 to
36.9 ft-lb.)
5. Add oil through the hole of the plug (1)
until the oil flows from the hole (3).
6. Tighten the plug (1) and (3).
· Tightening torque: 35 to 50 N · m (25.8 to
36.9 ft-lb.)
REPLACING THE HUB GEAR OIL
• Stop the engine and allow each part of
the machine to cool down before
performing maintenance.
· The hubs are hot immediately after the
engine is stopped. Touching them will
cause burns.
· The gear oil is also hot and under high
pressure immediately after the engine
is stopped.
Be careful not to touch the oil when
loosening the plugs. Working on the
machine under these conditions could
result in burns or injuries.
• The pressure in the reduction gear case
of hubs may cause oil or the plug to fly
out. Loosen the plug slowly to release
the pressure.
1. Set the hub so that the plug (1) is directly
below the hub.
2. Park the machine on a level surface and
stop the engine.
3. Place a pan under the plug (1) to catch the
waste oil.
4. Remove the plug (1) and drain the oil.
5. Set the hub so that the plug (1) is in a level
position.
6. Add oil through the hole of the plug (1)
until the oil flows from the hole.
7. Tighten the plug (1).
· Tightening torque: 35 to 50 N · m (25.8 to
36.9 ft-lb.)