COPY
‑B3‑
Nov./29/ 12
○
Adjust the free play at the throttle grip to be about
5 mm by turning the adjuster of the throttle cable.
☆
Follow the instructions of your throttle cable to adjust
the free play.
○
Dispose of the blow-by gas from the crankcase by
yourself.
(Some races and regulations stipulate the blow-by
gas disposal.)
○
In sending back the blow-by gas to the carburetor,
connect the blow-by hose with the union on the
air-filter.
(
See Optional parts chart on P-D1
)
○
Install an optional kick starter arm.
●
Engine oil
○
Remove the cap and add 850cc of engine oil.
○
Referring to the chart below, choose the engine oil
whose viscosity matches the region and outside
temperature.
○
Install the oil inlet cap.
○
Remove the top cover from the carburetor, and pull
out the spring and the throttle valve.
Pass the inner cable of the throttle cable through
the carburetor top cover and then through the
spring. And compressing the spring, fix the top
cover and all to the throttle valve. Fix the throttle
valve to the carburetor by aligning a notch on the
throttle valve with the throttle stop screw.
☆
In the case of VM26:
○
Insert the carburetor into the insulator, and fasten
them with a clamp band.
○
Attach an air filter, which please secure by
tightening a band.
Snap the throttle a few times to make sure that the
throttle moves smoothly without sticking and that the
throttle valve is fully open. And check that the throttle
has free play even when a steering handle is turned
all the way to the right or to the left.
※
In the case of installation to any model of the Gorilla,
replace the pre-installed fuel cock with the supplied
cock. Adjust the direction of the fuel cock and fasten
the nut to the fuel tank.
More free play
Adjuster
Less free play
About 5 mm
○
Insert a fuel tube and fasten it with a tube clip. Open
the fuel cock and check for oil leaks.
(Do not leave the cock open for many hours.)
Caution : Be sure to follow the specified torque.
Caution : Be sure to follow the specified torque.
Torque: 5
〜
6N
･
m (0.5
〜
0.6 kgf
･
m)
Oil Inlet Cap
