Takara Belmont Yume Oasis, Руководство по установке

Страница: 15 / 36

Corner adjuster
［
Resin case top view
］
Central adjuster
F.L
150
CAUTION
Arrange the adjuster so that it surely reaches the floor surface of the
frame. Otherwise, detachment/attachment of the upper unit may be
disturbed or the top panel may bend.
５
Adjust the adjuster
1. Loosen the level adjuster nut.
2. Use a nut driver or a wrench to turn the adjuster
for level adjustment.
Do not use an electric tool. It may cause damage.
(Arrange the adjuster so that it reaches the floor surface.)
●
The height is adjustable by the level adjusters of the floor unit up to 150 mm.
For adjustment exceeding 150 mm, provide a base of brick, block, and mortar, etc. inside of the reinforce-
ment frame to raise the level.
●
For level adjustment of the corner adjuster, it is convenient to use a nut driver or a deep socket with the
distance across flats of 17 mm.
Level adjuster nut
Resin case of floor unit
Resin case of
floor unit
3. Fasten the Level Adjuster Nut.
Level
adjuster nut
Adjuster
Adjuster
Long nut
1
2
Central adjuster
Corner adjuster
Note
Cap nut Cap nut
15
CAUTION
In the case of replacement with existing RS OASIS (use of the
mortar work form), adjust the central adjuster to reach the mortar
floor surface.
If the adjuster cannot reach the floor or the mortar surface is sandy,
lay bricks or blocks to make the adjuster reach it.
Central adjuster
Mortar work form
Block/brick
To turn the Level adjuster nut clockwise by a box or
wrench, loosen the nut.
The deep of adjuster is minimum at factory shipping.
Tighten the adjuster to the floor for adjustment.
POINT 1
POINT 2
※
Use a wrench to hold the adjuster and the cap nut in order to
prevent rotation of the adjuster while tightening the adjuster nut.
※
Make sure to fasten the central adjuster using the long nut
after completion of adjustment.