Takara Belmont Yume Oasis, Руководство по установке

Страница: 14 / 36

Make sure to fix resin case of floor unit with the
side of drain trap on the wall when fixing one.
Failure to follow this instruction may cause
difficulty to close the top panel.
CAUTION
Always make sure that there is no gap between the sash and the floor surface.
If there is a large gap between the sash and the floor panel, check for the adjuster hitting the bottom.
３
Fitting the floor unit into the floor
Long nut
Level adjuster
Resin case
Bury frame or reinforcement frame
* Hold here.
14
４
Fastening floor unit
Apply machine screws to the resin case of the floor
unit and fasten the screws to fit the case to the bury
frame or the reinforcement frame. (12 points)
Fasten the unit from the drain trap side as shown in
the image below.
If a screw is difficult to turn into the rafter, orient the
screw obliquely downward to fix.
[Mortar Bury Method]
[Composite Panel Platform Method]
Decorative floor panel
Mortar
bury frame
resin case of floor unit
Decorative floor panel
32
㎜
35
㎜
subflooring material
Rafter for mounting (45 mm square) resin case of floor unit
・
Machine screws for use (packaged with floor unit)
ø3.8 x 32 Coarse-led (SUS).
・
Machine screws for use (packaged with floor unit)
ø3.8 x 51 Coarse-led (SUS).
Machine screws
Sash Touch the
unit to the wall.
Floating No gap
finishing material
24
㎜〜
30
㎜
Cap nut
Hold the rotational shaft of the top panel swing and the
sash, and then fit the floor unit into the following parts;
・
Mortar bury method; bury frame
・
Reinforcement composite panel platform method;
reinforcement frame
To hold the rotational shaft which close to the center, you
can insert slowly and stably to the bury frame or
reinforcement frame.
Use a Cap Nut for adjustment of adjuster.
POINT 1
POINT 2
Rotational shaft
CAUTION
Drain trap
Sash