Takara Belmont Yume Oasis, Руководство по установке

Страница: 9 / 36

Always ensure the gradient of drain line
according to the number of units to be
installed as shown on page 4.
４
Laying the subflooring material
9
■ Composite Panel Platform Method
１
Marking (floor level)
Mark the floor level (F.L.)
140 mm or more
３
Piping
２
Illustrates the markings (installation position), the support legs and the base panel and
mark the position to place the floor unit.
※
Cut the panel + 50 mm larger around the attachment position.
Wall
D-dimension A-dimension
Marking lines
Hot water supply
Drain
Mirror
Base
Support Leg
Water supply
Refer to the Chair Arrangement Correlation Dimension
(on pages 30 to 34) that illustrates the markings (installa-
tion position), the support legs and the base panel and
mark the position to place the floor unit.
(The A-dimension and the D-dimension depend on the chair
to use and the reclined posture.)
As for markings, rule lines as many as possible so that you
can see the layout of the water supply Pipe, the hot water
supply Pipe and the drainpipe and the floor unit position.
Arrange the support legs and the floor base panel at this
timing.
Lay pipes to meet the floor unit position marked in Step 2 accord-
ing to the Plumbing Drawing on page 2.
For plumbing, check the position of the support legs to hold the
floor in advance and avoid the position to lay the pipes.
※
When the floor mount high rocks pump (SP-CH) is fastened
onto the floor, pay attention to the following dimensions:
＊
1
＝
350 mm or more
＊
2
＝
85 mm or less
＊
3
＝
68 mm or less
Make sure that the drainpipe does not have double trapping.
Drain failure or abnormal noises may occur.
Before laying the subflooring material, cut off the
opening in the floor base panel for the unit attach-
ment position.
Check the flexural level of the floor base panel with
the opening and place additional support legs.
CAUTION
F.L
＊
1
＊
2
＊
3
CAUTION
Floor unit installation position
＋
50
㎜
＋
50
㎜
＋
50
㎜ ＋
50
㎜