Tait TM8100 mobiles, Руководство по обслуживанию

Страница: 201 / 620

TM8100/TM8200 Service Manual Frequency Synthesizer Fault Finding 201
© Tait Electronics Limited November 2007
Task 9 —
DIG SYN EN
Line
If the supply for the charge pump and the reference frequency are correct,
check the
DIG SYN EN
line input.
1. Check the
DIG SYN EN
line at pin 10 of IC503 (see Figure 9.2 ).
Enter the CCTM command 334 0 to switch off the synthesizer, and
measure the voltage at pin 10.
2. Enter the command
334 1
to switch on the synthesizer, and measure
the voltage again.
3. If the voltages measured in Step 1 and Step 2 are correct, go to
Task 10 . If they are not, go to Step 4 .
4. Remove R104 (see Figure 9.7 ) and repeat the above measurements
as follows:
5. Enter the CCTM command
334 0
to switch off the synthesizer, and
measure the voltage at the via between R104 (see Figure 9.7 ) and
the digital board.
6. Enter the CCTM command
334 1
to switch on the synthesizer, and
measure the voltage at the via between R104 (see Figure 9.7 ) and
the digital board.
7. If the voltages measured in Step 5 and Step 6 are still not correct, the
digital board is faulty; replace the board and go to “Final Tasks” on
page 163 . If the voltages are correct, go to Step 8 .
8. There is a fault between the digital board and IC503 . Locate the fault.
Check and resolder R104 in position (see Figure 9.7 ), and check for
continuity between pin 10 of IC503 (see Figure 9.2 ) and the digital
board via R104.
9. If there is a fault, repair the circuit, confirm the removal of the fault,
and go to
“Final Tasks” on page 163 . If the repair failed or no fault
could be found, replace the board and go to “Final Tasks” on
page 163 .
pin 10 of IC503: 0V DC (after entry of CCTM 334 0)
pin 10 of IC503: 2.5
±
0.3V DC (after entry of CCTM 334 1)
via at R104: 0V DC (after entry of CCTM 334 0)
via at R104: 3.3
±
0.3V DC (after entry of CCTM 334 1)