Tait TM8100 mobiles, Руководство по обслуживанию

Страница: 400 / 620

400 CODEC and Audio Fault Finding TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
13.1 Power Supplies
Introduction
First check that a power supply is not the cause of the fault. Of these
supplies, the 3.3V DC supply (
+3
V
3
) will already have been checked in
“Power Supply Fault Finding” on page 169 . The remaining supplies that
need to be checked are:
■
Task 1 : 9V DC supply from 9V regulator (
+9
V
0
)
■
Task 2 : 3V DC supply from 3V regulator (
+3
V
0
AN
)
■
Task 3 : 2.5V DC supply from 2.5V regulator (
+2
V
5
CDC
)
Two other supplies used in the CODEC and audio circuitry are a 1.8V DC
supply (
+1
V
8
) from the digital board and the 13.8V DC supply (
+13
V
8
BATT
)
from the power connector. Faults in these supplies are dealt with elsewhere.
Task 1 —
9V Power Supply
First check the 9V DC supply (
+9
V
0
), which is required by IC201.
1. Remove the board from the chassis.
2. Remove the
CDC BOT
can.
3. Measure the voltage
+9
V
0
at pin 4 of IC201 (see Figure 13.1 ).
4. If the voltage is correct, go to Task 2 . If it is not, go to Step 5 .
5. The fault will be at IC201 (see Figure 13.1 ), since any fault with the
9V regulator in the PSU module will already have been rectified.
Therefore, check the soldering of IC201. Repair any fault.
6. Confirm the removal of the fault and go to “Final Tasks” on
page 163 . If the repair failed or the fault could not be found, replace
the board and go to “Final Tasks” on page 163 .
Task 2 —
3V Power Supply
If the 9V supply is correct, check the 3V DC supply ( +3
V
0
AN
) next.
1. Measure the voltage
+3
V
0
AN
at the
TP
601
test point
(see Figure 13.1 ).
2. If the voltage is correct, go to Task 3 . If it is not, go to Step 3 .
3. The 3V regulator IC603 is suspect (see Figure 13.1 ). Check the
regulator as described in Task 3 of “Power Supply Fault Finding” on
page 174 .
pin 4 of IC201: 9.0
±
0.3V DC
TP601 test point: 2.9
±
0.3V DC