Tait TM8100 mobiles, Руководство по обслуживанию

Страница: 93 / 620

TM8100/TM8200 Service Manual Circuit Descriptions 93
© Tait Electronics Limited November 2007
Input Signals
(
AUX GPI
1 to
AUX GPI
3 )
Dedicated inputs are provided on three pins of the auxiliary connector
(
AUX GPI
1 to
AUX GPI
3 ).
AUX GPI
1 is a general-purpose input with strong
protection of the same type used for
AUX GPIO
4
.
AUX GPI
2
is normally a
dedicated emergency input but can be made a general-purpose input like
AUX GPI
1 by removing the link LK3 in the power supply area.
AUX GPI
3 is
normally a dedicated ignition-sense input but can be made a general-
purpose input like
AUX GPI
1
by removing the link LK2 in the power supply
area and fitting the 33k
Ω
resistor R775.
ESD Protection
On exposed inputs of the auxiliary and control-head connectors ESD
(electrostatic discharge) protection is provided by a 470pF capacitor and by
clamping diodes to ground and to 13.8V. For example, on
AUX GPIO
4 this
consists of D713 and C725. The lines
IOP GPIO
1
to
IOP GPIO
7
are intended for
connection to internal digital devices and so these have relatively light
protection.
Hookswitch
Detection Hookswitch detection is performed by Q700, R709, R706 and R712.
When the resistance to ground on the PTT line is less than 13.2k
Ω,
Q700
will turn on and drive the
ITF CH HOOK
line high; this indicates either that the
microphone is on hook or that the PTT (press-to-talk) switch is pressed.
3.8 Digital Board
Introduction
Different digital boards are used for the TM8200 and TM8100 radios.
For a block diagram of the digital board of the TM8200 radios, refer to
Figure 3.13 . For a block diagram of the digital board of the TM8100 radios,
refer to Figure 3.14 .
The digital board is not serviceable at level-2 and is not described in this
manual.