Tait TM8100 mobiles, Руководство по обслуживанию

Страница: 115 / 620

TM8100/TM8200 Service Manual General Information 115
© Tait Electronics Limited November 2007
4.4 Setting up the Test Equipment
This section covers the setting up of the test equipment for servicing the
radios, as well as related aspects:
■
setting up of test equipment, including test unit
■
basic programming and calibration tasks
■
invoking CCTM (computer-controlled test mode)
■
summary tables of CCTM commands and error codes
■
visual and audible indications provided by radio
The last-named aspect applies to control heads with UI, and concerns the
STATUS
LEDs and LCD screen, and the various alerts and confidence tones
emitted from the speaker.
Connect Equipment
Connect the test equipment to the radio as shown in Figure 4.2 . Use the test
unit, cables and adaptor of the service kit. Refer to “Tools, Equipment and
Spares” on page 110 for details of the test equipment and service kit.
The test unit is described in “TOPA-SV-024 Test Unit” on page 613 .
For testing receive and transmit functions respectively, the switches of the
test unit must be set as described below. (When programming or calibrating
radios the switches have no effect, although it is good practice to set the
MODE
switch to
“R
X
”
.)
Settings for
Receive Tests
For receive tests set the switches on the test unit as follows:
■ HOOK
switch :
“O
FF
H
OOK
”
■ MODE
switch :
“R
X
”
■ AUDIO IN
switch :
“O
FF
”
■ AUDIO OUT
switch:
“S
PEAKER
”
or
“L
OAD
”.
In the last-named case, with the switch in the “S
PEAKER
” position, the
received audio is output from the test unit’s speaker. In the
“L
OAD
”
position a
16
Ω
load is switched into the circuit in place of the test unit’s speaker.
Note, however, that the
AUDIO OUT
switch has no effect on the radio’s speaker.
Settings for
Transmit Tests
For transmit tests set the switches on the test unit as follows:
■
HOOK
switch : “O
FF
H
OOK
”
■ MODE
switch : “R
X
” initially
■
AUDIO IN
switch : “M
IC
A
UDIO
”
■
AUDIO OUT
switch: (immaterial).
When ready to transmit, set the
MODE
switch to the “T
X
/PTT” position.
This switch functions in the same way as the PTT switch on the
microphone.
Product Support CD
Install the programming and calibration applications on the test PC.
These applications are included on the product support CD supplied with
the service kit.