CNC-210A Series H6681 User manual
Page
12
of
20
έᚊཝҋજ̼ѣࢨ̳Φ
TAILY AUTOMATION CO.,LTD.
8. INSTALLATION
AND
WIRING
The controllers should be operated in an environment that is protected from moisture,
corrosive gases, or liquid, and free from airborne dust, metallic particles, and magnetic noise.
Do not block the intake/exhaust ports of the controller. Otherwise, a fault may occur.
Make sure that the power source supplies the correct voltage and is capable of supplying the
required current to the controllers.
Do not connect or disconnect wires and connectors while power is applied to the controller.
Make sure the machine and controllers are properly grounded.
Make sure that the leads and connectors are connected correctly.
Normally operate under 10
℃
~ 40
℃
environment
;
over 40
℃
should perform under good
ventilation, avoid heating.
8.1. Accessories and options
NAME
CNC-210AS
CNC-210AE
210A-CN2
RS-485 Connection box
○
○
210A-CN3
Operate switches connection cable
○
○
210A-CN4
Home sensor connection cable
○
○
210A-CN5
Counting sensor connection cable
○
○
210A-CN6
Aux I/O signal connection cable
○
○
210A-CN7
Pulse output
connection cable
×
○
210A-CN8
AC output connection cable
×
○
HOME-SR
Home sensor
○
○
CNTB-03B/C
Counting sensor
○
○
DISC
Counting disc
○
○
START
Push button switch
○
○
STOP
Push button switch
○
○
RESET
Push button switch
○
○
Foot switch
RUN/STOP Foot switch
○
○
Power cord
AC Power cord
○
○
×
= not use in this model
