Tailift TPR1230, Руководство по эксплуатации, Страница: 62 / 99

6-7
6.7 Adjustment of the clutch(for TPR-1600H/TPR-2000H)
While the spindle can’t rotate fully to drill, the clutch is wear to drill, the clutch is wear to
drill,the clutch is weared, you can adjust device, as following.
a. Change gear speed to the highest speed, turn off
power.
b. Remove oil sight glass.
c. Rotae spindle by your left-hand until clutch turns to
the best position for adjustment, clutch’s key faces
outside.
d. Push upper key(down key) out, turn collar
right(left) a little for adjustment, until the key
comes back notch automatically.
* If clutch “L”(“H”) speed can’t rotate fully while
drilling, you should adjust upper key
(down key)
e. Put oil sight glass.
f. Operate spindle to drill, check if sindle can rotate
while drilling.