Tailift TPR1230, Руководство по эксплуатации

Страница: 38 / 99

5-9
5.3 Installation of the clamp
（
work piece
）
5.3.1 General
Work piece must be placed securely and precisely on the radial drill so that precision and
safe procession can be achieved. Regularly, a vise is applied. (as shown picture a). Since
the vise has its range limit, universal clamp (as shown picture b) is applied for bulky
work piece or any work piece which isn’t easy to be clamped. The universal clamp
includes T shape chamfer bolts, stacking plate, insertion blocks, which makes clamping
easier.
5.3.2 Introduction of the vise and the clamping of the work piece.
(1) The fixed side of the vise.
(2) The fixing side with T shape chamfer bolt and nuts
(3) The moving side of the vise.
(4) The screw bar.
(5) The
handle.
(6) The surface of the vise.
Clamp work piece as the following
：
a. Move away the drilling bit or lift the gearbox to the utmost point.
b. Using brush, clean the worktable and the vise surface.
c. Clean the vise surface using clean rag.
d. Position the work piece on the vise surface. If it is piercing drilling, please insert a
block under the work piece so that drilling into vise can be avoided.
e. Fasten the handle by rotating it clockwise and tighten it. While tightening it, please
use plastic hammer or copper bar to hit the work piece till there is no gap between
the work piece and the inserted block.