Tadpole 2003 Tadpole, Руководство пользователя

Страница: 13 / 31

Page 13 Tadpole Hot Tub Owner’s Manual — January 24, 2003
ECONOMY CONTROL SYSTEM
MASTER CONTROL PAD (Figures I-1 & 2)
Temp Set (80°F - 104°F)
The start-up temperature is set at 100°F. The last meas-
ured temperature is constantly displayed on the LED.
Note that the last measured hot tub temperature dis-
played is current only when pump 1 (“Jets ” )has been
running for at least 2 minutes .
Press the “Temp” button to display and adjust the set
temperature. After three seconds, the LED will
automatically display the last measured temperature.
Jets
Touch the “Jets” button once to activate the low speed of
pump 1 and again for the high speed. Press the “Jets”
button again to turn off pump 1. If left running, the
pump’s low speed will automatically turn off after 2
hours, and the pump’s high speed will automatically turn
off after 30 minutes. The pump’s low speed runs when
the hot tub is heating, when a filter cycle is activated, or
when a freezing condition is detected. If the pump’s low
speed is on under Automatic Spa Control, it can only be
deactivated by entering the Standby Mode.
Light
Press the “Light” button to turn the light on and off. If
left on, the light automatically turns off after 4 hours.
Modes
Press “Temp”, then “Auxiliary” ( to switch between
Standard, Economy, and Sleep Modes.
Standard Mode is programmed to maintain the desired
temperature. Note: the last measured hot tub tem-
perature displayed is current only when pump 1 has been
running for at least 2 minutes. “
St ” will be displayed
momentarily when you switch into standard mode.
Economy Mode heats the hot tub to the set temperature
only during filter cycles. “ Ec ” will display solid when
temperature is not current, and will alternate with tem-
perature when temperature is current.
Push “Jets” to shift to Standard-in-Economy Mode,
indicated by
“SE” alternating with the temperature. The
spa operates the same as it does in Standard Mode, but
reverts to Economy Mode automatically after 2 hours.
During this time, a press of the “Temp” then “Auxiliary”
buttons will revert to Economy Mode immediately.
Note: Heating will occur more quickly in Standard-in-Economy
Mode if a low-speed (versus a high speed) pump is operating.
(Figure I-1) Economy Control Pad