Tadpole 2003 Tadpole, Руководство пользователя

Страница: 11 / 31

Page 11 Tadpole Hot Tub Owner’s Manual — January 24, 2003
(Figure F-2) Spa Fittings
(Figure E) Drain Cap
(Figure G) Fill Level Indication Mark
CHECKLIST BEFORE FILLING YOUR
HOT TUB
Important: The equipment should never be operated
without water in the hot tub. Serious damage to the
pump and/or heater may occur.
1. Installing Your Cover: Your hot tub cover comes
with tie-down straps and locking hardware to attach the
cover to the hot tub or decking. If your Dealer did not
install your cover, then refer to Cover Installation
Instructions that come in the cover cardboard packaging.
2. Check Drain-Cap: At the end of the drain hose
(located in the Equipment Compartment) is the Drain-Cap
(Fig. E) Make sure it is securely fastened to the end of the
drain hose.
3. Tighten Equipment Fittings: In the equipment
compartment, hand-tighten all PVC Pipe Unions and
Pump Drain Plugs (Figs. F1-2) to prevent the possibility of
leakage (sometimes these fittings loosen during
shipment).
4. Fill the hot tub: Fill the hot tub to approximately
the Water Level mark (Fig. G) on the face plate of the
filter assembly. (See Note 2).
Note 1: To avoid air pockets in the pumps and in the
main plumbing intake, it is recommended that the hot
tub be filled through the filter assembly.
Note 2: The higher the water level, the less hot tub
occupants it will take to cause the water to overflow the
top of the hot tub.
Note 3: Do not fill the hot tub with soft water unless the
mineral content is raised immediately (see your Dealer).
5. Check for Leaks: After the hot tub is full, but
before turning the power on, check all the fittings and
equipment in the equipment compartment for signs of
leakage. If a leak is detected, except from fittings that
can be hand-tightened, call your authorized Tadpole Hot
Tub Dealer.
(Figure F-1) Spa Fittings