Tachosys digidl, Руководство по установке

Страница: 22 / 28

digiDL - Installation
DigiDL Installation Guide Page - 22
digiDL Indicator Lights
The digiDL has three indicator LEDs (see
Fig 15.)
each of which has one of three statuses; ON / OFF or
Flashing. See the table below for details on the meaning of each light status.
Please note that when the power LED (Red) is on and the CAN-Bus LED (Green) is off it would sug-
gest that either the CAN-Bus C connector is not connected correctly or the vehicle ignition is off.
If the GREEN LED is not illuminated the Tachograph may not be of the correct type (see page 4-5) or
the manufacturer may not have enabled the Secondary CAN-Bus (CAN2) on the Tachograph (see
below).
VDO and secondary CAN-Bus enabling
Some VDO Tachograph may be configured with the Secondary CAN-Bus disabled by default. In this
case the function will need to be enabled with a CTC II programmer with 2.6 firmware or later or
Stoneridge Optimo or other suitable Tachograph programmer.
If the CAN LED (GREEN) LED does not illuminate on the digiDL and the Tachograph has a Secondary
CAN-Bus this is the likely cause.
Most DAF models and many Renault models come with the second CAN and Remote Download
turned OFF by default.
P: Power Status C: CAN-Bus C
W: GPRS or
WIFI Status
Fig 15.
LED ON OFF Flash
P Power Okay No Power Power okay and a Task is in progress
C CAN okay No CAN Infers intermittent CAN connection
W Comms okay No Comms Slow flash (1 per sec) = No Comms,
Fast = GPRS comms OK but no server.