T3 Motion MotionTrak 330 4CH, Руководство пользователя

Страница: 10 / 52

FUNCTION (MAIN UNIT)
Automatic start
Make sure that peripherals including all cameras are properly connected.
Turn on the vehicle power the MotionTrak330 4CH automatically start (Use
Turn on the vehicle power, the MotionTrak330 4CH automatically start. (Use
the power cable provided.)
Event record
The Event recording will be started automatically by motion detection Alarm 1
Notice : The unit will not begin recording immediately after the power is
applied, it takes approximately 1 minute for the built-in power backup
system to charge. Thereafter, the internal flash memory will be ready to record.
The Event recording will be started automatically by motion detection, Alarm 1
to 3 or by the G-sensor level.
The Panic recording can be started by pressing the [PANIC] button.
Normal record (Continuous record)
The Normal (continuous) recording will be automatically started after power on.
The MotionTrak330 4CH will not create a separate event file during the
continuous recording mode. It will mark the Event area as ‘Alarm 1~3’, G-sensor,
motion detection or [PANIC] button in the continuous recording file which can
motion detection or [PANIC] button in the continuous recording file, which can
be easily searched for during playback.
Dual record (Event & Normal record)
If different record modes are set for each camera, like camera1 set as Event
record and camera2 set as Normal record, then camera1 (Event record) will
work according to the record setting for example 10 frames per second
recording. However camera2 (Normal record) will record 1 frame per second, if
there is no event. If there is an Event, both cameras will record according to the
Live screen on Monitor
The MotionTrak330 4CH will display the live screen on the monitor.
The camera channel can be changed using the information OSD.
(Refer to page 13)
Playback in the car
record setting for example 10 frames per second recording.
10
Recorded files can be played back in the vehicle.
PC Viewer Software
This software is pre-loaded on the SD card [pcsw] folder.