T-Drill PLUS 115 SS:, Инструкция по эксплуатации

Страница: 7 / 80

PORTABLE
COLLARING SYSTEM
7
PLUS 115
2.1 GENERAL SAFETY INSTRUCTIONS FOR WORK AREA
Keep work area clean
– Cluttered areas and benches invite injuries.
Consider work area environment – Don’t use power tool in humid or wet conditions.
Keep work area well illuminated. Don’t use power tool in the presence of flammable
liquids or gases.
Keep children away – Do not let visitors touch the tool or it`s extension cord. All visitors
should be kept away from work area.
Stay alert – Be aware of what you are doing. Use common sense. Do not operate tool
when you are tired.
2.2 SAFETY INSTRUCTIONS FOR TOOL
Store idle tools – when not in use, tools should be stored in dry, high, or locked-up place,
out of the reach of children.
Don’t force tool – It will do the job better and safer at the rate for which it is intended.
Dress properly – Do not wear loose clothing or jewelry. They can be caught in moving
parts. Use appropriate gloves and footwear. Wear protective hair covering to contain long
hair.
Use safety glasses – Also use face or dust mask if cutting operation is dusty.
Secure work
– Use clamps or a vise to hold your work piece. It’s safer than using your
hand and it frees both hands to operate the tool.
Don’t overreach – Keep proper footing and balance at all times.
Maintain tools with care – Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Inspect tool cords
periodically and, if damaged, have them repaired by authorized service workshop.
Inspect extension cords periodically and replace if damaged. Keep handles dry, clean and
free from oil and grease.
Don’t abuse cord – Never carry a tool by its cord or yank it to disconnect it from
receptacle. Keep cord from heat, oil and sharp edges.
Disconnect tools
– When not in use, before servicing, and when changing accessories
such as blades, bits and cutters.
Remove adjusting keys and wrenches – Make it a rule to check that keys and adjusting
wrenches are removed from tool before turning it on.
Avoid accidental starting – Do not use a tool if the power switch does not turn the tool
on and off. Do not carry the tool with your finger on the switch.
Outdoor use extension cords
– When tool is used outdoors, use only extension cords
intended for use outdoors and so marked.
Check damaged parts – Before further use of tool, a guard or other part that is damaged
should be carefully checked to determinate that it will operate properly and perform
its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an
authorized service unless otherwise indicated elsewhere in this instruction manual. Have
defective switches replaced by an authorized service. Do not use tool if switch will not
turn it on and off.