T-Drill PLUS 115 SS:, Инструкция по эксплуатации

Страница: 20 / 80

INSTRUCTION
MANUAL
20
The base plate and elliptic pilot hole
device can be attached to the tube in
only one position: The base plate locking
lever pointing to the left, and the pilot
hole device adjustment part in front of
the operator.
8.2 MAKING OF THE PILOT HOLE WITH ELLIPTIC DEVICE
Adjustment of the pilot hole measures A and B
The A and B dimensions of the ellipse are
adjusted by loosening the locking screws
(Adjust scales separately, so that the locking
screws are open only one at a time). The
adjustment is done by sliding the scale in
the desired direction. The diameter of the
milling pin is screened on the same line as
the desired dimension and tightening the
screw. The best size of the milling pin is
proved to be 11.3mm.
Note, the scale only reads 10 and 20, start
with 10, and test.
Attaching the elliptic pilot hole device to the base plate
The pilot hole cutter is placed to the base
plate so, that the control system is towards
the operator. Device is lowered to base plate
the same way as the PLUS 115 gearbox:
the bottom mounting pins are placed
in the holes and turning the ellipse unit
counterclockwise until the ellipse is straight
on the base plate.
The locking of the device is done by two
systems: the locking lever attached to the
base plate (2), and the pilot hole cutter with
an attached orange screw handle (1). The
lever (2) also locks the PLUS 115 gearbox to
the basic plate.
Attaching the T-65 to the elliptic pilot hole device