Performing Advanced Configuration
SYSTIMAX® AirSPEED™ AP542
User Guide
58
Figure 4-18 Automatic Configuration Screen
Configuring Automatic Configuration for Dynamic IP
Perform the following procedure to enable and set up Automatic Configuration when you have a dynamic IP address
for the TFTP server via DHCP.
The Configuration filename and the TFTP server IP address are contained in the DHCP response when the AP gets its
IP address dynamically from the DHCP server. A Syslog server address is also contained in the DHCP response,
allowing the AP to send Auto Configuration success and failure messages to a Syslog server.
NOTE
The configuration filename and TFTP server IP address are configured only when the AP is configured for
Static IP. If the AP is configured for Dynamic IP these parameters are not used and obtained from DHCP.
1. Click
Configure
>
Management
>
AutoConfig
.
The
Automatic Configuration Screen
appears.
2. Check
Enable Auto Configuration
.
When the AP is Configured with Dynamic IP, the DHCP server should be configured with the TFTP Server IP address
("Boot Server Host Name", option 66) and Configuration file ("Bootfile name", option 67) as follows (note that this
example uses a Windows 2000 server):
3.
Select DHCP Server
>
DHCP Option
>
Scope
.
The
DHCP Options: Scope
screen appears.
Содержание AirSPEED AP542
Страница 1: ...SYSTIMAX AirSPEED AP542 User Guide www systimax com SYSTIMAX Structured Connectivity Solutions ...
Страница 42: ...Performing Advanced Configuration SYSTIMAX AirSPEED AP542 User Guide 42 Figure 4 9 Operational Mode Screen ...
Страница 76: ...Performing Advanced Configuration SYSTIMAX AirSPEED AP542 User Guide 76 Figure 4 25 Rogue Scan Screen ...
