- 13 -
User instructions
Pressure controller REP 6/10
1. General directions
1.1 Transport Storage
•
The controllers are packed and wrapped for normal transport demands.
•
Controllers must be stored damp-free and protected from climatic effects prior to final
assembly.
2. Safety
2.1 Symbol Key
The symbols below warn for danger and refer to special cautionary measures.
Warning! General hazard!
Danger from electric current or voltage!
Important information!
2.2 Electrical Equipment
Installation and connection must be carried out by qualified personnel complying with
valid electrical safety regulations (e.g. EN 60204, ELSÄK FS 1994:7).
•
Enclosure classification when open is IP00!
•
The controller must be sealed or enclosed in the control cubicle when in service.
•
Fuses must always be replaced, not repaired or strapped.
•
Observe fuse sizes.
Any electrical malfunctions must be rectified immediately.
The controller must not be used in a faulty state even if no immediate danger is
imminent.
