59
S.1.1.1
Design of protection measures
Inside the doors are additional protection installed – guards that only can be removed by use of tools.
S.1.1.2
Configuration of controller in EC motors with installed guard
A controller is mounted in the EC motor. If the configuration of the controller is carried out with the fan in operation, the
guard must be installed for safety reasons and a long cable must be installed between the EC motor inside the unit and
the control panel outside the unit.
The mentioned guard is an accsesory that must be ordered separately.
S.1.2
Safe adjustment and maintenance
Before maintenance and repair, the unit must be switched off by switching off the disconnecting device.
Note that
lamps must be switched on during maintenance
(lamps are an accessory – only installed, if ordered).
Use cut-resistant gloves for protection against injury from sharp metal plate edges. Use CE-marked gloves for this pur-
pose. Use helmet during maintenance work in the unit.
S.1.3
Personal protective equipment for maintenance staff – health and safety
Use the below-mentioned personal protective equipment for maintenance:
• Cut-resistant gloves for protection against injury from sharp metal plate edges. Use CE-marked gloves for this
purpose.
• Helmet
• Particulate respirator – maintenance free including foam face-seal and adjustable pre-threaded headbands – for re-
placing filters.
• Padlock for locking the above mentioned automatic circuit breakers.
• Permanent magnet motor. The shaft must be blocked during repairs and maintenance of the electric system (the
motor generates electricity by rotation – for example that the wind and thermic drives the fan/motor).
T
The specifications of the spare parts to be used, when these affect the health
and safety of operators
Geniox air handling units are operating automatically. Operators can control the unit by the Systemair control panel
T.1
Spare parts - Mechanical
Annex 3 - available on demand
T.2
Spare parts - Electrical
Annex 3 - available on demand
output |