System Equine TRC-6, Руководство по сборке

Страница: 3 / 8

BLADE POST & BLADE
A-frame
STEP 2
Blade
Blade
Post
Blade
Post
Guides
TRACK & RING CONDITIONER ASSEMBLY INSTRUCTIONS
TRACK & RING CONDITIONER ASSEMBLY INSTRUCTIONS FOR MODELS: TRC-6 / TRC-8 / TRC-PULL-BEHIND-6 & 8
STEP 1
INSTALLING TINES ON TINE BAR
See fig. STEP 1 photo before proceeding.
1. Place tine bar between two supports as shown in STEP 1 photo (we used
the top and bottom of the shipping boxes anything that will give you at least
8” clearance will do.)
2. Place first tine on tine bar as shown in FIG 1A & FIG 1B . Attach and tighten
using 3/8” x 1 1/2” bolts and lock nuts. Repeat process until all tines are in
place.
NOTE: Tines should be spaced approximately 6” apart on center for the TRC-6
and 7” for a TRC-8.
THIS FINISHED SECTION WILL BE CALLED THE
TINE BAR ASSEMBLY.
STEP 2
ATTACHING THE BLADE POST AND BLADE TO THE A-FRAME
See STEP 2 photo before proceeding
1. Position the blade post in the guides on the rear of the A-frame with blade
angle adjustment holes facing towards the front of the A-frame as shown
FIG 2A .
2. Using a 3/4” x 4 1/2” bolt put flat washer on bolt and put bolt through A-
Frame hole sliding into top of centre Blade Post hole. Tighten using 1 1/8”
wrench or ratchet & socket. NOTE: There is a nut is welded on to bottom
side of Blade Post Plate. (Make sure that the front hitch pin is in front hole
so Blade Post does not turn.)
3. Tighten the bolt and nut completely and then back off 1/4 turn to allow for
movement of the blade post.
4. Then drop in the 3/4” drop pin through the A-frame into a blade post adjust-
ment hole. Next position the blade face down and lift the blade post and
A-frame placing it into the slot on the back of the blade, and attach using the
3/4” x 5” bolt and lock nut FIG 2B . Again tighten completely and back off 1/4
turn to allow for movement. NOTE: leave blade assembly unfinished at this
time this will make the unit more stable for the rest of the assembly.
Tine
Clamp
FIG 1A
Tine
Clamp Bolt
FIG 1B
Box top & bottom used as supports
TINE BAR ASSEMBLY
Tine bar assembly mounting brackets
Tines at spaced at 6” for TRC-6 or 7” for TRC-8
Tine Bar
STEP 1
Blade post guides
FIG 2A
Blade
FIG 2B