PROTOUCH-WIDE MONITOR: user documentation - PRELIMINARY
DOC/PROTOUCH-WIDE_MONITOR; V0.2
DOC_PROTOUCH-WIDE_MONITOR_V0.3.docx
Seite 8 von 35
© 2019 Syslogic Datentechnik AG | All rights reserved
1.8.3
Electro Static Discharge
Electronic boards are sensitive to Electro-Static Discharge (ESD). Please ensure that
the product is handled with care and only in an ESD protected environment.
Otherwise a proper operation is not guaranteed.
1.8.4
Battery
Changing batteries
Danger of explosion if the battery is not correctly replaced. Replace only with the same
or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
Maintenance of battery
Empty batteries may leak.
Never short the battery.
1.8.5
Hot surface
Attention! Hot surfaces
Make sure the device is not hot before mounting or changing the installation. The
device may be hot and may cause burs.
1.9
Life Cycle Information
1.9.1
Transportation and Storage
During transportation and storage, the products must be in their original packing. It is recommended, to keep the original packing in case of
return of the product to the factory for repair. Note that the packing is recyclable.
1.9.2
Assembly and Installation
Observe the EMI-precautions against static discharge. Carefully read the installation documentation before unpacking the product.
The installation procedures must be strictly observed. Note that deviations from the installation guidelines may result in degraded operational
reliability or in unfavourable EM-radiation or EM-susceptibility.
1.9.3
Operation
The operating environment must guarantee the environmental parameters (temperature, power supply, etc.) specified in the technical
specification section of this document.
The main functionality of the product is defined by the application program. The application program is not part of the delivery by Syslogic but
is defined, developed and tested by the customer or a system-integrator for each specific application. Refer to the respective documentation for
more information.
1.9.4
Maintenance and Repair
In the rare case of a product hardware-failure or malfunction, the complete product should be exchanged. The faulty product must be returned
to the factory for repair. Please use whenever possible the original packing for return of the product (EMI and mechanical protection).
