Synxcom SM9234D, Руководство пользователя

Страница: 59 / 216

AT Commands
Page 59
0 Enables short-form (terse) result codes. Line feed is
not issued before a short-form result code.
1 Enables long-form (verbose) result codes. (Default.)
Result Codes
OK <value> = 0 or 1
ERROR Otherwise.
W - Connect Message Control
This command, along with S95, bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be written
directly by the host or by the +MR, +ER, and +DR commands, respectively),
control the format of CONNECT messages (see Table A-2). The actual result
code messages reported reflect the W command setting and the S95 bit settings.
(Also see +MR, +ER, and +DR commands.)
The W parameter value, if valid, is written to S31, bits 2 and 3.
Syntax
W<value>
Defined Values
<value> Decimal number corresponding to the option.
0 Upon connection, the modem reports only the DTE
speed (e.g., CONNECT 19200) Subsequent responses
are disabled. (Default.
1 Upon connection, the modem reports the modulation,
line speed, the error correction protocol, and the DTE
speed, respectively .Subsequent responses are
disabled.
2 Upon connection, the modem the DCE speed (e.g.,
CONNECT 14400). Subsequent responses are
disabled.
Result Codes
OK <value> = 0 or 1
ERROR Otherwise.
X - Extended Result Codes
This command selects the subset of the result code messages used by the modem
to inform the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. To enforce dial tone
detection, a "W" can be placed in the dial string (see D command). The
information below is based upon the default implementation of the X results table.
Table A-2 indicates the messages which are enabled for each X value.
If the modem is in facsimile mode (+FCLASS=1, 1.0, or 2), the only message sent
to indicate a connection is CONNECT without a speed indication.