Synthes LCP Distal Humerus Plates, Руководство по технике

Страница: 15 / 28

Synthes 13
7
Insert distal screws LCP 2,7 mm
Required instruments
Holding Sleeve for LCP Screw Stardrive 2.4/2.7 mm 313.301
Screwdriver Shaft Stardrive, T8, cylindrical, with groove 313.304
Torque Limiter, 0.8 Nm, with AO/ASIF Quick Coupling 511.776
The LCP locking screw can be inserted manually or by power
tool.
Use the screwdriver shaft, attached to the torque limiter.
Use the holding sleeve if necessary.
A “click” indicates that the screw is locked into the plate.
Important: always use TLA when inserting LCP locking
screws, otherwise plate and/or screws might be damaged
Option: Use cortex screw 2.4 mm
Repeat the above steps for all distal holes to be used.
Important: It is recommended to use minimum one screw on
the lateral side which crosses the distal block. Screw length
should be 40–60mm depending on the size of the humerus.
The recommended screw length for the capitellum is
16–24 mm.
Important: When inserting the screws into the capitellum, be
careful not to damage the joint due to the length of the
screws. It is recommended to check the position of the screws
with the image intensifier during movement of the elbow.
LCP Distal Humerus Plates
Dorsolateral plate with support