SYNTEK 60CA, Руководство по эксплуатации

Страница: 51 / 139

机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction
–
d.
•
•
•
e.
•
•
•
f.
•
•
g.
•
•
•
•
•
•
•
h.
•
•
•
•
•
•
•
a.
•
b.
•
c.
•
•
•
•
•
•
•
•
•
•
•
•
Percentage ratio
G00 percentage
G01 percentage
Spindle speed percentage
Total Acum Par
Total work pieces that had been finished.
System won't do any initialized action automatically.
If you want to do the initialization by manual, press
「
Parameter Set
」
switch to
「
Part
count
」
, set the
「
Total Acum Par
」
as 0.Part Count
Part Count
Count no. will begin from zero when the program is running.
Total work pieces number machined by CNC
Start Block
We can set the start block of machining process.
n: Set the start line number as n. (Ex. 20)
L+n: Set the start line number as n. (Ex.L20)
N+n: Search N+n located line number and then assign that line as the start line (Ex. N3).
T+n: Search T+n located line number and assign it as the start line (Ex. T01).
If line number is out of max line number, then it will assign to the last line.
Please refer to 3.4.3.4 break point initialization about start block go back.
Tool Data
T
4 numbers
The first two code are the tool no..
The last two code are the tool compensate no.
Display Area of Machining Setting
Description
This area is overlap with
「
Machining Information
」
, press F4
「
Parameter Set
」
to change the
displays.
Explanation of Display:
Interrupt Line No.
Display the last interrupted serial number (N)
Interrupt Colum No.
Display the last interrupted line number (L)
Spindle speed
Speed of spindle.
It is allow to setting when system is busy. Moreover, it will be enabled immediately
Feed rate
Set the speed of the feed rate.
。
It is allow to setting when system is busy, but the value will be updated after completely
executing processing block.
Total AcumPar
Total work pieces number machined by CNCSystem cannot automatically reset this value to zero
Part count
Setting current work pieces no.
Count no. will begin from zero when the running program is change.
When CNC executes M code defined by parameter 3804, part count would be added 1 and run
time will be reset to 0. When required part number is reached, system will change to halt status.
Required part