SYNTEK 60CA, Руководство по эксплуатации

Страница: 108 / 139

机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller
–
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Length complength wear = real G43/G44 compensate.
Manual Measurement of Tool Length
Purpose
Describe how to use manual measurement to set tool length and work piece coordinate in order
to set the machining tool.
Function
We usually set the tool length and offset in the External Shift if we only use one tool in this
machine.
If we have more than one tool, we need to set every tool length we can use relative length or
absolute length.
Operation condition
Manual mode.
Manual Operation method
-Relative method.
Use manual function moving the reference tool to the Z-coordinate code 0 position of the
workpiece (Ex. surface), set the value at G54.
Clean all the relative coordinate value.
Install the measured tool, move the tool to the same position as before (reference surface).
The tool length is the different between measured tool and reference tool.
Key in this number to the corresponding tool No.
If tool break during machining and replace a new tool, we need to change to a new tool. If the Z-
cord 0 position already disappear, we can use the standard tool to touch anywhere of the
machine and then use new tool to touch the same position. The relative cord. is tool length.
-Absolute method
Use manual function moving the measuring tool to a reference point (Ex. Work piece table).
Measure every tool repeatedly.
Move the machining tool to the reference position, clean all the relative coordinate.
Move the tool to the Z-coord code zero position, set it to G54.
If tool break during machining so we need change a new tool, we must touch the reference
position first, and then the Z coordinate value is tool length.
Tool Tip Measure
Function
Measuring different tool No. tip position. Because the trigger position of tool alignment
equipment is fixed, user can use different tool tip position key in the workpiece coordinate
system for the reference of tool length offset. You must check this machine has tool alignment
equipment.
Operation Method
Offset/Setting → Tool Tip Measure