Synergy SG1300, Руководство пользователя и инженера по установке и конвертации, Страница: 27 / 28

27
Installation Tips and Advice for Gas Installation Engineer:
•
THIS UNIT MUST BE INSTALLED BY AN AUTHORISED PERSON.
•
There must be a 50mm gap along the front to allow component cooling.
•
This appliance requires a
¾
” gas supply/catering hose.
•
Familiarise yourself with the cleaning regime –
PLEASE STICK THE
LAMINATED DAILY CLEANING GUIDE ON A WALL NEAR THE
APPLIANCE
and explain to the Kitchen Manager call-outs due to this
problem may not be covered under warranty.
•
Do not remove the ceramics bricks when moving the grill. HOWEVER, if
you must remove them to position the grill into a tight space you must
ensure the ceramic insulating paper is re-installed correctly; by that we
mean every air hole in the corner of every ceramic block is open and you
can see the smaller hole in the metalwork behind the ceramic.
•
Ensure the Ceramic Ring is orientated correctly – the three nodules
should be at the bottom of the ring, and the ring should fit flush with the
surrounding ceramic bedding.
•
Do not use an external inline gas governor – outlet/burner regulation is
achieved via the appliances internal valve.
•
Ensure the Outlet Pressure is as stated on the appliances Data Plate
using a Manometer and 2.5mm Allen Key – e.g. 15.0mbar for G20 Natural
Gas, or 37mbar for Liquid Propane Gas. Please ensure you check the
pressures with all other appliances, such as hobs and ovens that the
kitchen would have running during normal service, on whilst you check
the outlet/burner port pressure -
Working pressures.
•
“Switch On and Walk Away” - This appliance can take up to 40 seconds
before full ignition and may take up to three attempts before the flame
holds.