SYN-INT-E01
9
them using the + or - button and confirm your choice by
pressing down the Mode or Day/Hr button.
4. The two figures indicating the minutes blink. You must adjust
them using the + or – button and confirm your choice by
pressing down the Mode or Day/Hr button. The adjustment
is then completed and the thermostat returns to the previous
mode.
N.B.
At any time, you can exit the adjustment mode of the day and
the hour by pressing down the Exit button or by not pressing
any button during 1 minute.
In case of a power failure, the thermostat is self-sufficient for 2
hours. If the failure lasts less than 2 hours, the thermostat saves
the adjustment of the hour and the day of the week. When the
power is restored after an extensive failure (more than 2 hours),
the hour and the day of the week are recovered, but you must
update them.
Display in Degrees Celsius/Fahrenheit
The thermostat can display the ambient temperature and the set
point in degrees Celsius (standard factory setting) or Fahrenheit.
Adjustment procedure for degrees Celsius/Fahrenheit display.
1. To switch from the degrees Celsius to the degrees Fahrenheit,
and conversely, simultaneously press down the + and -
buttons for more than 3 seconds until the SET icon blinks.
2. Press down the + button to switch from the degrees Celsius
to the degrees Fahrenheit, and conversely. The degree
Celsius or Fahrenheit symbol is displayed.
3. When the adjustment is completed, press down the Exit
button or do not press down any button during 5 seconds to
exit the adjustment function.
N.B.
This adjustment can be done from any of the three principal
modes.
