SYN-INT-E01
15
Choice of the Preprogramming
You can only access the Preprogramming mode when the ther
-
mostat is out of any programming or adjustment function. Make
sure to choose the preprogrammings corresponding to the right
mode (Ambient /Floor, according to the attached tables).
You must proceed as follows to access the Preprogramming
mode:
1. Press down the Pre Prog button.
2. The Pre Prog icon and saved selected preprogramming are
displayed. This preprogramming can range between 0 and
Z1.
3. From the Pre Prog mode, you can choose the first 10
preprogrammings by pressing and releasing the Pre
Prog button. Each time you press down the button, the
preprogramming switches (from 0 to 9).
4. To choose advanced preprogrammings, (see appendix 1),
press down the Pre Prog button during 5 seconds. The letter
indicator blinks and you can adjust it by pressing down the +
or – button. Once the letter is chosen, you must validate your
choice by pressing down the Mode button. The letter ceases
to blink and the figure starts to blink. The choice of the figure
is made in the same way as that of the letter (using the + or –
button). Once the figure is selected, you must validate your
choice by pressing down the Mode button.
N.B.
If you do not press down any button for more than one minute
or press the Exit button, the thermostat exits the adjustment
function and saves the current choice. Then, the icons cease
to blink and the letter and the figure corresponding to the
selected preprogramming blink alternately until you select
another preprogramming. If the Pre Prog mode is activated
and you successively press down the Pre Prog button, the
preprogramming comes back to 0 and increases normally, as
described above.
