SYN-INT-E01
14
Erasing of the Programming
You must proceed as follows to erase a programming period.
1. Access the Programming mode as described previously
by pressing down the button corresponding to the day to
modify. Select the period to erase using the + or – button.
2. You do not have to press down the Mode button to confirm
the selection. However, doing so will not impact on the
erasing.
3. Simultaneously press down the + and – buttons to erase
the period programming. The hour displays – -:- – and the set
point displays – – to indicate that the programming is erased.
4. The erased period number blinks and you can select
another period to be erased or exit the Programming mode
following one of the 3 methods described above.
Preprogrammed Mode
The Preprogrammed mode allows an automatic programming
of the thermostat. 252 preprogrammings have been defined for
Ambient mode and 252, for Floor mode (A0 to Z1 and 0 to 9;
see appendix 1 to consult the corresponding tables). This mode
gives you the possibility to quickly program the thermostat us-
ing preprogrammings commonly used without having to do it
manually.
As from the Automatic mode, it is possible, at any time, to man-
ually adjust the set point. This set point will be effective until the
next set point change anticipated by the preprogramming. Note
that if the set point is lowered to OF, the programming will not
be effective.
From this mode, the screen displays the Ambient/Floor temper-
ature, the Ambient/Floor set point, the hour, the day of the week
and the letter and current number of the preprogramming
(A0 to Z1 and 0 to 9; alpha-numeric segment displayed on the
right-hand side of the hour; see appendix 1, p. 23).
