Symantec GHOST IMAGING FOUNDATION 7.1, Руководство пользователя

Страница: 82 / 189

Table 6-2
Access method switches (continued)
Description Switch
Forces USB support to start, even when the USB controller is being
run by something else (DOS only).The -forceusb switch attempts to
take over the USB Host Controller and then attempts to return it to
the previous state once the Ghost operation is complete. This works
for controllers as follows:
■
EHCI controllers with BIOS support are taken over and then
returned to the BIOS.
■
UHCI controllers with BIOS support are taken over and then
returned to the BIOS.
For example, the keyboard is returned after the Ghost operation
is finished.
■
OHCI controllers with BIOS support are taken over but not returned
to the BIOS.
Note the following:
■
Use this switch with caution.
■
Avoid using the forceusb switch to take over a USB controller from
a driver, for example, the Ghost peer-to-peer USB driver. You may
encounter problems if you do this.
/forceusb
Tuns off the IEEE1394 (Firewire) support (DOS only). /no1394
Tuns off the IDE support (DOS only). /noide
Tuns off the SCSI support. /noscsi
Tuns off USB support (DOS only). /nousb
Specifies that the preferred file system access is through the operating
system. /osfs
Specifies that the preferred volume access is through the operating
system. /osvol
Sets the path to the directory in which the recovery file system resides. /pfpath=path
Sets the USB emulation timeout in microseconds, where n is greater
than or equal to 1 (DOS only). The default setting is 3000ms. /usbtimeout=n
Verifies every disk write. /vdw
Manipulating files and directories using OmniFS
Using OmniFS
82