7
ExTINgUISHINg THE FLAME
wArNiNg - NEvEr ExTiNguisH THE FLAmE wiTH
wATEr!
wArNiNg - risK oF FirE ANd BurNs, do NoT
pour ouT THE ETHANoL wHiLE iT is HoT.
wArNiNg - ETHANoL is A FLAmmABLE LiQuid ANd
sHouLd BE HANdLEd cArEFuLLy.
1) Let the fuel burn out completely if possible. This prevents
alcohol odours left in the reservoir and deflagration when
reigniting (before refill or closing down).
2) If you wish to extinguish the flame before the fuel is
completely burned out, push the front handle of burner
until opening of burner is completely closed. It is not
recommended to leave ethanol inside the fuel reservoir while
it is not in use.
If the flame will not fully extinguish immediately. Leave the
burner closed. Do not blow air into the burner - It will not
help to extinguish the flame but will actually cause the flame
to become bigger by increasing the combustion. Wait for
flame to extinguish before leaving flame unattended.
REFILLINg
wArNiNg - risK oF FirE ANd BurNs. do NoT Add
FuEL iNTo A BurNiNg FLAmE.
wArNiNg - risK oF FirE ANd BurNs. do NoT Add
FuEL iNTo HoT BurNEr.
1) After the flame is extinguished, allow the burner to cool down
at least 15 minutes before refilling.
2) When the burner is cooled down, follow the steps in
OPERATION section to restart.
CLEANINg ANd MAINTENANCE
wArNiNg - THE BurNEr musT BE ExTiNguisHEd
ANd compLETELy cooLEd dowN BEForE ANy
cLEANiNg or mAiNTENANcE cAN BE cArriEd ouT.
1) Remove the burner from the drawer.
2) Clean the burner with a damp cloth.
3) Do not pour water into fuel reservoir. It causes moisture/
water accumulation inside and affects the effectiveness of
burner.
4) Clean the glass and other areas of fireplace with a damp cloth.
FUEL STORAgE
wArNiNg - sTorE FuEL AwAy From cHiLdrEN
ANd ANimALs. KEEp FuEL coNTAiNEr compLETELy
cLosEd wHiLE NoT iN usE.
1) Do not store more than 5 liters/1.3 gallon of flammable liquid
in your home.
2) Store fuel at room temperature to facilitate ignition.
3) The burner and fuel must not be exposed to direct heat such
as direct sunlight and other heating sources.
REpAIR SET
TOUCH-Up REpAIR pAINT
Paint directly on the mantel unit if necessary. Fig. A.
Fig. A
REpAIRS
If any problems are found with the original parts during mantel
assembly such as the panels cannot be installed with the plastic
connector. Try to solve by one of the following methods.
Tools required:
Electric drill, drill bits 3/4 inch (10 mm) or 1/16
inch (2 mm), pencil, hammer, Philips screwdriver, safety goggles
and gloves (if necessary).
WARNINg:
wEAr EyE proTEcTioN BEForE you
sTArT driLLiNg.