4
MANTEL ANd INSERT ASSEMbLY:
NoTE:
Place a piece of cardboard or protective sheet on the floor
in order to avoid scratching the decorative surface of your mantel
during assembly. Please DO NOT fully tighten the KD screws until
all panels are assembled.
NOTE:
If the KD screw(s) do not fit during assembly, loosen
the 2 screws to adjust the plastic connector until the PANEL/ KD
screws are able to be installed. Tighten all KD screws once all
panels are assembled.
Step 1: Attach plastic connectors [X] to Panel C, D, E, F and G
as shown in Fig. A (2 pcs KD screws for each plastic
connectors). Attach 2 wood connectors [R] to panel D and
E with 4 KD screws.
Fig. A
Step 2: Attach panel D to panel F with 2 KD screws. Attach panel
E to panel G with 2 KD screws. See Fig. B.
Fig. B
Step 3: Attach panel D and F to base panel [B] with 2 KD screws.
Attach panel E and G to base panel [B] with 2 KD screws.
See Fig. C.
Fig. c
Step 4: Attach panel C to the unit as shown in Fig. D with 4 KD
screws. See Fig. D.
Fig. d
Step 5: Attach left corner support [J] and right corner support [K]
to Left and right side panels [G and H] as shown in Fig. E.
Fig. E