5
Step 6: Attach top panel [A] to the unit as shown in Fig. F with 3
KD screws. See Fig. F.
Fig. F
Step 7: Attach corner panel [H] to top panel [A] with 6 mounting
screws [T]. See Fig. G.
Fig. g
Step 8: Attach fireplace insert to the mantel unit with 4 mounting
brackets [S] and 4 KD screws. Attach 2 mounting screws at
each side of the insert. See Fig. H.
Fig. H
WALL ANCHOR SAFETY CAbLE
cAuTioN - THis cABLE mAy rEducE possiBLE
risK oF iNjury iF THE FirEpLAcE is impropErLy
HANdLEd, BuT is NoT A suBsTiTuTE For propEr
AduLT supErvisioN. cHiLdrEN sHouLd NoT BE
LEFT uNATTENdEd NEAr ANy ETHoNAL FirEpLAcE.
The use of wall anchor safety cable is highly recommended
in order to reduce the risk of the fireplace being tipped over
accidentally.
1) Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall
anchor into the hole and gently tap until the flange on the
anchor is against the wall surface.
2) Position the back edge of the mantel close to the wall.
3) Attach the safety cable to the mantle using the screw for
mantle. See fig. I.
Fig. i
4) Use the screw for wall to attach the other end of safety cable to
the wall.
5) Make sure all screws are tight.
OpERATION
1) Push safety shutoff lever up to “OFF” position and then pull the
burner holder out toward you. You will see the fuel reservoir
(fill hole). See Fig. 1
.