k) Time-based daily restriction for output #1 - programming code 56
If start and end time for a time-based restriction are programmed here, they will be applied daily
until they are deleted again.
This function is based on the real-time clock. Therefore, it is imperative that the clock
is set before programming (see Chapter 14. j).
For safety reasons, output #1 can also be enabled by touching the door opener button
or entering the superuser code.
If the start time is earlier than the end time, the time restriction ends on the same day.
If the start time is later than the end time, the time restriction does not end until the
next day.
Programming time-based daily restriction for output #1:
•
The code lock should be in programming mode, see Chapter 14. b).
•
General input for programming:
Programming code
Start time
End time
Confirmation
HH : MM
HH : MM
•
Programming code
56
•
Start time
:
HH : MM
start time in hours and minutes; allowed is 00:00 - 23:59.
is made in 24-hour format; the first two digits “
HH
” stand for the hours;
the other two digits “
MM
” are minutes; the seconds always start at 0
•
End time
:
HH : MM
end time in hours and minutes; allowed is 00:00 - 23:59.
• Confirmation
:
Press the
button to confirm your entry.
The code lock emits two beep tones and the centre LED flashes twice orange. Programming
is saved.
• When you have finished programming, exit programming mode with the
button.
98
