Sygonix 1698497, Руководство по эксплуатации

Страница: 43 / 120

43
8. Assembly/connection of the outdoor unit
a) General information
The outdoor unit should be mounted in an area protected from direct rainfall (for example, near the front door under a
canopy) so that the visitor stands directly in front of it when pressing the call button. The camera should be mounted
at the height of about 150 cm, depending on the environment conditions at the place of installation.
Take care that cables or lines are not damaged while drilling and/or bolting down! The same applies to lay-
ing the connection/connection cable (voltage/power supply and door opener) and any necessary masonry
work.
The outdoor unit can be powered by an adapter or alternatively by batteries (not included).
You should test the video door intercom system at the future place of installation before you drill the holes
for fixed installation and lay the cable.
Mount the outdoor unit only on a stable surface, but not on metal surfaces or near any other electrical/
electronic equipment, as this will negatively affect the radio range.
Take care that cables or lines are not damaged while drilling and/or bolting down! The same applies to
laying the connection/connection cable and any necessary masonry work.
b) Operation via batteries, insert/change batteries
Important!
If the device is operated by a power supply (and possibly an additional UPS), batteries must not be in-
serted.
If the outdoor unit (E) must be powered by batteries, first remove the four screws
(A) and then remove the square battery compartment cover (B) (note the place-
ment).
Insert two baby/C batteries (C) with the correct polarity into the battery compart-
ment (D); pay attention to the correct polarity (plus/+ and minus/-), see labels on
the batteries and in the battery compartment.
Then replace the battery compartment cover (B) and secure it with the previously
removed four screws (A). Pay attention to the correct placement of the battery
compartment cover.
During battery operation, the power-saving mode is automatically ac-
tivated. Here, it is not possible to activate the outdoor unit from the
handset (monitor function).
However, this can be changed, see chapter 11. c).